Skip to content
Black Friday Black Friday deals end in 00Days 00Hrs 00Min 00Sec Shop Deals
Free Shipping on most orders over $150.00. Buy now, pay later with ShopPay                    
Free Shipping on most orders over $150.00. Buy now, pay later with ShopPay                    

FASS No Drop Titanium Signature Series Plus Fuel System with Sump, 290 GPH | 2008 to 2010 Ford 6.4 Powerstroke | NDTSPF16290G

Part#:

NDTSPF16290G
Original price $0.00 - Original price $0.00
Original price $0.00
$979.00
$979.00 - $979.00
Current price $979.00
Description

The FASS No Drop Titanium Signature Series Plus NDTSPF16290G is a 290 GPH fuel system with a water separator, 2 micron filter and air and vapor separation for the 2008 to 2010 Ford 6.4 Powerstroke. The factory frame rail pump on the 6.4 has no air separation and little room for added fuel demand. A FASS system replaces it outright.

This No Drop kit pairs the TSPF16290G system with the FASS SK5501 fuel sump, so you can put a sump in the bottom of the tank without dropping it. The sump pulls fuel from the lowest point of the tank, which keeps the pump from sucking air on hills and hard turns when the tank is low.

The Plus version is the same Titanium Signature system with O ring boss (ORB) fittings, black anodized 6061 aluminum fittings and black fuel line, for a cleaner install and fewer leak points.

  • Fits: 2008 to 2010 Ford F250 and F350 Super Duty with the 6.4L Powerstroke
  • Part number: NDTSPF16290G
  • Flow: 290 GPH
  • Horsepower rating: 1,200 to 1,500 hp, per FASS
  • Filtration: PF-3001 particulate filter on the suction side and XWS-3002 extreme water separator, 2 micron absolute, on the pressure side
  • Includes: TSPF16290G fuel system and SK5501 sump kit
  • Warranty: FASS limited lifetime warranty when the system is registered
  • Made in: Marthasville, Missouri

What It Does

A factory lift pump moves fuel and that is all. It does not pull out air, vapor or water. Air in the fuel throws off injector spray and timing, and water is the fastest way to kill a high pressure pump. A FASS system pulls fuel through a particulate filter that catches the larger debris before it reaches the pump, then pushes it through the extreme water separator, which traps the water and filters down to 2 microns absolute. Entrained air and vapor are separated out before the fuel ever reaches the injection pump.

FASS uses a Mass Flow Return design. Fuel the engine does not use goes back to the tank after it has been through the filters, so the fuel in your tank keeps getting cleaned every time you drive. The motor is FASS's quiet Whisper design, and the housing has radiused internal passages instead of sharp 90 degree corners so air is not mixed back into the fuel.

Which Flow Rate Do You Need?

FASS sizes each flow rate by horsepower. This 290 GPH unit is rated for 1,200 to 1,500 hp. A bigger pump will not hurt a stock truck, since the fuel the engine does not use goes back to the tank through the filters, but there is no reason to pay for flow you will never use.

Other flow rates in this kit for your truck: 100 GPH (stock to 600 hp), 165 GPH (600 to 1,000 hp), 250 GPH (1,000 to 1,200 hp).

Same flow rate, different kit: Titanium Signature Series, Titanium Signature Series Plus, No Drop Titanium Signature Series.

Filters and Cold Weather

The system uses two spin on filters: the PF-3001 particulate filter on the suction side and the XWS-3002 extreme water separator, rated 2 microns absolute, on the pressure side. FASS rates them for about 30,000 miles. The easiest way to keep spares on hand is the FP3000 filter pack with two of each. Want longer cans? The FP3000XL has the extended length XWS-3002XL and PF-3001XL, if you have the room under the housing. If your truck sees real winters, the housing has ports for the HK-1001 electric heater kit.

Not sure which flow rate fits your truck and your power level? Send us your VIN and mods, or call 865 640 2097 and talk to a tech who works on these trucks every day. Comparing brands? Read our FASS vs AirDog lift pump guide.

Warranty

You may also like

  • RCD Regulated Return Fuel Bowl Delete | 2008 to 2010 6.4 Powerstroke | RCD 1740490003

    RCD Performance
    Original price $449.99 - Original price $449.99
    Original price
    $449.99
    $449.99 - $449.99
    Current price $449.99

    RCD Performance part number 1740490003 Replaces the 6.4 Powerstroke fuel bowl with a regulated return setup so you can set and hold the fuel pressu...

    View full details
    Original price $449.99 - Original price $449.99
    Original price
    $449.99
    $449.99 - $449.99
    Current price $449.99
  • Industrial Injection 6.4L Reman Fuel Pump (Pump Only) | 2008 to 2010 Ford 6.4 Powerstroke | 334301

    Industrial Injection
    Original price $1,020.95
    Original price $1,020.95 - Original price $1,020.95
    Original price $1,020.95
    Current price $990.32
    $990.32 - $990.32
    Current price $990.32

    Industrial Injection Part #: 334301Fits:2008 to 2010 Ford F250, F350, F450 and F550 Super Duty with the 6.4L Power Stroke.Important Fitment Info:Re...

    View full details
    Original price $1,020.95
    Original price $1,020.95 - Original price $1,020.95
    Original price $1,020.95
    Current price $990.32
    $990.32 - $990.32
    Current price $990.32
    Save 3% Save %
  • Ford 8C3Z-9G805-B High-pressure Fuel Pump (hpfp) Installation Kit

    Ford
    Original price $350.00 - Original price $350.00
    Original price
    $350.00
    $350.00 - $350.00
    Current price $350.00

    IN STOCK Make installing the high-pressure fuel pump in your 2008-2010 Ford 6.4L Powerstroke a breeze when you use the Ford 8C3Z-9G805-B High-Pr...

    View full details
    Original price $350.00 - Original price $350.00
    Original price
    $350.00
    $350.00 - $350.00
    Current price $350.00
  • XDP Fuel Tank Sump, One Hole with Fuel Return XD243

    XDP
    Original price $185.95 - Original price $185.95
    Original price
    $185.95
    $185.95 - $185.95
    Current price $185.95

    XDP Fuel Tank Sump, One Hole with Fuel Return XD243. Sold and shipped by Powerhouse Diesel, a diesel repair and performance shop in Knoxville, TN. ...

    View full details
    Original price $185.95 - Original price $185.95
    Original price
    $185.95
    $185.95 - $185.95
    Current price $185.95
  • DDP Common Rail High Pressure Diesel Injection System Cleaner

    DDP
    Original price $0.00 - Original price $0.00
    Original price $0.00
    $47.50
    $47.50 - $47.50
    Current price $47.50

    A heavy duty, one time use cleaner for the whole common rail fuel system. It removes contamination and resin buildup. Part number: DDPCRCLEAN Ques...

    View full details
    Original price $0.00 - Original price $0.00
    Original price $0.00
    $47.50
    $47.50 - $47.50
    Current price $47.50