Skip to content
Black Friday Black Friday deals end in 00Days 00Hrs 00Min 00Sec Shop Deals
Free Shipping on most orders over $150.00. Buy now, pay later with ShopPay                    
Free Shipping on most orders over $150.00. Buy now, pay later with ShopPay                    

FASS No Drop Titanium Signature Series Plus Fuel System with Sump, 240 GPH | 2017 to 2022 Ford 6.7 Powerstroke | NDTSPF18290F240G

Part#:

NDTSPF18290F240G
Original price $0.00 - Original price $0.00
Original price $0.00
$1,069.00
$1,069.00 - $1,069.00
Current price $1,069.00
Description

The FASS No Drop Titanium Signature Series Plus NDTSPF18290F240G is a 240 GPH fuel system with a water separator, 2 micron filter and air and vapor separation for the 2017 to 2022 Ford 6.7 Powerstroke. The 6.7 runs a Bosch CP4.2, the pump you least want to see air or water. Clean, air free fuel at steady pressure is the best protection you can give it.

This No Drop kit pairs the TSPF18290F240G system with the FASS SK5501 fuel sump, so you can put a sump in the bottom of the tank without dropping it. The sump pulls fuel from the lowest point of the tank, which keeps the pump from sucking air on hills and hard turns when the tank is low.

The Plus version is the same Titanium Signature system with O ring boss (ORB) fittings, black anodized 6061 aluminum fittings and black fuel line, for a cleaner install and fewer leak points.

  • Fits: 2017 to 2022 Ford F250 and F350 Super Duty with the 6.7L Powerstroke
  • Part number: NDTSPF18290F240G
  • Flow: 240 GPH
  • Horsepower rating: 1,100 to 1,500 hp, per FASS
  • Filtration: PF-3001 particulate filter on the suction side and XWS-3002 extreme water separator, 2 micron absolute, on the pressure side
  • Pressure: high pressure model, about 65 PSI, for this engine
  • Includes: TSPF18290F240G fuel system and SK5501 sump kit
  • Warranty: FASS limited lifetime warranty when the system is registered
  • Made in: Marthasville, Missouri

What It Does

A factory lift pump moves fuel and that is all. It does not pull out air, vapor or water. Air in the fuel throws off injector spray and timing, and water is the fastest way to kill a high pressure pump. A FASS system pulls fuel through a particulate filter that catches the larger debris before it reaches the pump, then pushes it through the extreme water separator, which traps the water and filters down to 2 microns absolute. Entrained air and vapor are separated out before the fuel ever reaches the injection pump.

FASS uses a Mass Flow Return design. Fuel the engine does not use goes back to the tank after it has been through the filters, so the fuel in your tank keeps getting cleaned every time you drive. The motor is FASS's quiet Whisper design, and the housing has radiused internal passages instead of sharp 90 degree corners so air is not mixed back into the fuel.

Which Flow Rate Do You Need?

FASS sizes each flow rate by horsepower. This 240 GPH unit is rated for 1,100 to 1,500 hp. A bigger pump will not hurt a stock truck, since the fuel the engine does not use goes back to the tank through the filters, but there is no reason to pay for flow you will never use.

Other flow rates in this kit for your truck: 140 GPH (stock to 700 hp), 220 GPH (700 to 1,100 hp).

Same flow rate, different kit: Titanium Signature Series, Titanium Signature Series Plus, No Drop Titanium Signature Series.

Filters and Cold Weather

The system uses two spin on filters: the PF-3001 particulate filter on the suction side and the XWS-3002 extreme water separator, rated 2 microns absolute, on the pressure side. FASS rates them for about 30,000 miles. The easiest way to keep spares on hand is the FP3000 filter pack with two of each. Want longer cans? The FP3000XL has the extended length XWS-3002XL and PF-3001XL, if you have the room under the housing. If your truck sees real winters, the housing has ports for the HK-1001 electric heater kit.

Not sure which flow rate fits your truck and your power level? Send us your VIN and mods, or call 865 640 2097 and talk to a tech who works on these trucks every day. Comparing brands? Read our FASS vs AirDog lift pump guide.

Warranty

You may also like

  • SPE Disaster Prevention 2.0 Kit | 2011 to 2026 6.7 Powerstroke | S100297

    SPE
    Original price $0.00 - Original price $0.00
    Original price $0.00
    $375.00
    $375.00 - $399.00
    Current price $375.00

    SPE Motorsport part numbers S100297 (2011 to 2014), S100298 (2015 to 2016), S100299 (2017 to 2019) and S100300 (2020 and newer). 50 state compliant...

    View full details
    Original price $0.00 - Original price $0.00
    Original price $0.00
    $375.00
    $375.00 - $399.00
    Current price $375.00
  • RCD Performance CPX Injection Pump | 2011 to 2027 6.7 Powerstroke | 1750400010

    RCD Performance
    Original price $1,099.99 - Original price $1,999.00
    Original price
    $1,099.99
    $1,099.99 - $1,999.00
    Current price $1,099.99

    RCD Performance part numbers 1750400010, 1750400020, 1745400001, 1760400001, 1760400002 and 1760400003. Patent US 12,698,751 B1. $200 core charge, ...

    View full details
    Original price $1,099.99 - Original price $1,999.00
    Original price
    $1,099.99
    $1,099.99 - $1,999.00
    Current price $1,099.99
  • SPE Gen 2 Billet Fuel Drain Valve | 2017 to 2026 6.7 Powerstroke | S100102

    SPE
    Original price $0.00 - Original price $0.00
    Original price $0.00
    $64.99
    $64.99 - $64.99
    Current price $64.99

    SPE Motorsport part number S100102 (replaces S100114) The SPE 2017 to 2026 6.7 Powerstroke Gen 2 Billet Fuel Drain Valve is a stronger, permanent f...

    View full details
    Original price $0.00 - Original price $0.00
    Original price $0.00
    $64.99
    $64.99 - $64.99
    Current price $64.99
  • S&S Gen 2.1 CP4 Disaster Prevention Kit | 2011 to 2026 6.7 Powerstroke | CP4-6.7F-BP-G2.1

    S&S
    Original price $400.00 - Original price $400.00
    Original price
    $400.00
    $400.00 - $400.00
    Current price $400.00

    S&S Diesel Motorsport part number CP4-6.7F-BP-G2.1 When the CP4 on a 6.7 Powerstroke comes apart, the metal it sheds goes straight into the rai...

    View full details
    Original price $400.00 - Original price $400.00
    Original price
    $400.00
    $400.00 - $400.00
    Current price $400.00
  • S&S CP4 to DCR Pump Conversion | 2011 to 2026 6.7 Powerstroke | 6.7F-DCR-1

    S&S
    Original price $2,400.00 - Original price $2,400.00
    Original price
    $2,400.00
    $2,400.00 - $2,400.00
    Current price $2,400.00

    S&S Diesel Motorsport part number 6.7F-DCR-1 Take the CP4 off your 6.7 Powerstroke and replace it with a pump built to last. The CP4 is known f...

    View full details
    Original price $2,400.00 - Original price $2,400.00
    Original price
    $2,400.00
    $2,400.00 - $2,400.00
    Current price $2,400.00